IHG series 100 kHz to 1100 kHz high frequency induction heaters are among the latest products developed by Across International. They can quickly heat most metals that other frequencies can not heat efficiently, like aluminum and metal powders. And uniquely they can heat parts from a distance. These heaters are the ideal tools for fine steel wires (such as those used in dentistry) annealing, small precision shaft quenching, hard alloy saw blade brazing and metal powders melting.
Specially designed for welding thin metal parts, blades and melting of small quantity of metallic powder, ultra fast.
Ease of use: just plug in the power and connect the cooling system. Our simple instruction allows you to use the heater in 15 minutes.
Light weight (only 20 kg), portable (with built-in handle), instant heat and up to 90% energy savings
Precise control with digital output, frequency and current displays.
Remote foot switch for a safer operation.
Dual automatic and manual modes.
Optional graphite, MgO and SiO2 crucibles available. (melting material decides crucible type, weight and size of the material decide crucible size)
Frequency is non-adjustable, it depends on the coil design (diameter of turns, numbers of turns, copper tubing diameter and total length).
ISO 9001:2008 registered manufacturer.
Safety
Overvoltageprotection: machine shuts down, overvoltage light turns on and buzzer sounds continuously when line voltage exceeds 295V. Alarm shuts off automatically when voltage returns below 295V.
Overheatprotection: if sensor detects heat sink temperature is over 55°C, machine shuts down, overheat light turns on and buzzer sounds continuously. Decrease water temperature until alarm goes off.
Overcurrent/malfunction protections: machine shuts down, indicator light turns on and buzzer sounds continuously in one of these situations:
Short circuit exists between work piece and induction coils
One of the machine parts becomes overheated
Interfering signal detected
Machine malfunctions
Induction coils touching each other
Line voltage is too low
Low water pressure protection: if water pressure goes below 29 PSI, machine will shut down, water protection light will turn on and buzzer will sound continuously.
IMPORTANT
Always wear protective gear including goggles when operating the machine. Crucibles must be covered at all times during operation. Across International is not responsible for any injury or damage caused by misuse.
Running without a work-piece for extended periods of time may cause damage to the machine.
Circulating water must be pure, soft and below 45°C.
Machine must be grounded properly at all times.
Use of single-turn coils smaller than 100 mm in diameter may cause high frequency damage to the machine.
Absolutely no thread tape (or related material) may be used in the installation of induction coils.
