13mm Diameter ID Vacuum Dry Pressing Die Set

Specifications

• Maximum Pressure:         15 tons
• Rockwell Hardness:          Rc 62
• Diameter (ID):                 13 mm
• Height:                           75 mm (assembled without sample)
• Sleeve Height:                 40 mm
• Sleeve Diameter (OD):     39 mm
• Tolerance:                      0.01-0.02 mm (10-20 micron)
• Material:
  • Core die & push rod:          W18Cr4V hardened carbon tool steel
  • Sleeve, ejector & support:  Cr12 hardened carbon mold steel
    
• Max sample fill height:     Not to exceed 1/3 of the sleeve height
  

Die set includes

• Two 13mm ID core dies made of highly polished hardened steel
• One steel sleeve with vacuum connector
• One steel support plate
• One pushing rod
• Rubber sealing o-rings
• One steel cylinder pellet ejector

Important

• Always wear protection goggles and gear during operation
• Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
  
• Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 15 tons. Across International is not responsible for any damage caused by misuse.