A set of 25mm diameter (ID) hardened steel trapezoidal split sleeve dry pressing die set for pellet presses, ready for you to make 25mm diameter cylinder-shape pellets.
These die sets are professionally built for you to work with samples that tend to stick to the inner surface of the sleeve, trapezoidal split inner sleeves with pellet ejector make sample releasing a snap.
Die set includes
Two 25mm diameter cylinder-shape core dies made of highly polished hardened steel
One outer sleeve with trapezoidal inner wall
Three trapezoidal inner sleeves
One support plate
One push rod
One pellet ejector
Important
Always wear protection goggles during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never fill the die more than 2/3 its sleeve height with your sample and do not apply pressure beyond 30 tons. Across International is not responsible for any damage caused by misuse.
Specifications
Maximum Pressure: 30 metric tons
Rockwell Hardness: Rc 62
Diameter (ID): 25 mm
Height: 100 mm (assembled without sample)
Sleeve Height: 53 mm
Sleeve Diameter (OD): 70 mm
Trapezoidal Sleeve OD (top): 25 mm
Trapezoidal Sleeve OD (bottom): 31 mm
Weight: 6.5 lb
Tolerance: 0.01-0.02 mm (10-20 micron)
Material:
Core die & push rod: W18Cr4V hardened carbon tool steel
Max sample fill height: Not to exceed 2/3 of the sleeve height
Die set includes
Two 25mm diameter cylinder-shape core dies made of highly polished hardened steel
One outer sleeve with trapezoidal inner wall
Three trapezoidal inner sleeves
One support plate
One push rod
One pellet ejector
Important
Always wear protection goggles during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never fill the die more than 2/3 its sleeve height with your sample and do not apply pressure beyond 30 tons. Across International is not responsible for any damage caused by misuse.